Insta360 GO Ultra Pivot Stand

Set the Angle, Keep Your Hands Free Put the camera where the view works, rather than where a tripod happens to fit. The Insta360 GO Ultra Pivot Stand combines a reusable sticky base with an adjustable ball joint and a magnetic fixed-claw latch. It supports the standalone GO Ultra camera or the Action Pod, giving you a compact option for a tabletop recording, a creative viewpoint or a hands-free piece to camera on a suitable surface. Highlights Fits the standalone GO Ultra camera and the Action Pod Reusable, washable sticky base for suitable dry surfaces Adjustable ball joint for flexible framing Magnetic fixed-claw latch with side-button release Quarter-inch mounting point for additional support options Key Features Choose a Suitable Surface The flexible sticky base is designed for dry, smooth surfaces that are flat or only slightly curved. Open the protective cover, press the base firmly in place for ten seconds and check the attachment before releasing the camera. Surface preparation matters more than the size of the stand. Camera or Action Pod, Your Choice The magnetic fixed-claw connection accepts GO Ultra on its own or seated in the Action Pod. Align the camera with the icon and make sure the latch is properly engaged. This lets you choose the smaller standalone setup or keep the Pod’s screen and controls with the camera. Fine-tune the Viewpoint Use the adjustable ball joint to aim the camera after placing the base. A quarter-inch mounting point gives another connection option when a separate compatible support is more appropriate than the sticky base. Keep the full arrangement balanced and within the conditions suitable for the support. Care for the Base Between Shoots The hinged cover stays with the stand, helping keep the adhesive surface clean during storage. Wash the sticky base as directed when needed, allow it to dry and replace the cover. Remove it using the base’s lift tab rather than pulling the whole stand away from the surface. Summary A compact, reusable positioning accessory for GO Ultra, with a flexible viewpoint and a positive camera connection for everyday creative setups. Frequently Asked Questions Does It Fit the Camera Without the Action Pod?ExpandCollapse Yes. The magnetic fixed-claw latch is designed for both the standalone GO Ultra camera and the camera with its Action Pod. Can the Base Stick to Any Surface?ExpandCollapse No. Use a dry, smooth surface that is flat or slightly curved. Textured, wet or unsuitable surfaces may not provide a secure attachment. How Do I Attach the Sticky Base?ExpandCollapse Open the base cover, press the base onto the prepared surface and hold for ten seconds. Check that it is secure before letting go. Can I Clean and Reuse the Base?ExpandCollapse Yes. The manufacturer describes a washable, reusable sticky base. Follow the cleaning instructions, let it dry and keep the cover on when stored. How Do I Remove It Without Damage?ExpandCollapse Detach the camera using the side buckles, then lift the tab on the base to release it. Do not pull the entire stand directly away from the surface. Read more