Insta360 Bike Tail Mount Kit

Bring The Whole Ride Into View The Insta360 Bike Tail Mount Kit moves a compatible camera away from the bike for a wider third-person perspective. Its two-point arrangement supports an approved selfie stick using both the seat-rail mounting assembly and a seat-post fixing. Adjust the angle while stationary, then record the rider, bike and surroundings from a position a direct-mounted camera cannot provide. Highlights Two-point support using the seat rails and seat post Adjustable mechanical joints for setting the shooting angle Seat-rail components included for a compact direct-camera setup Supports manufacturer-approved Invisible Selfie Stick models For flat-road cycling at no more than 60 km/h Key Features A Third-Person Perspective Without Flying With a compatible 360° camera and suitable Invisible Selfie Stick, the extended position can bring the rider and bike into the same view. The camera and stick are sold separately. Set a sensible rear or side-rear position that stays within applicable road rules and clear of other road users. Use Both Mounting Points The tail-mounted fixing works together with the seat-rail support clamp. Do not support a selfie stick and camera from the tail clamp alone. The combined arrangement is part of the specified installation, so tighten both points and check the assembly before each ride. Match The Clamps To The Seat Post Choose the bracket arrangement that matches the post’s shape and confirm the actual fit. Non-round posts generally require two brackets, while a round post normally uses one. Use the supplied silicone protection as instructed, and add suitable cushioning if needed to protect the post’s finish. Two Useful Setups In One Kit The supplied seat-rail components can also hold an appropriate camera directly beneath the saddle. For an extended setup, use a supported stick and the full two-point arrangement. The joints are mechanically adjustable; they do not provide powered electronic stabilisation. Road Filming With Clear Limits This kit is intended for flat roads at no more than 60 km/h, not bumpy, mountain or muddy roads. Insta360 recommends the Action Invisible Selfie Stick, 114 cm Invisible Selfie Stick or 85 cm Invisible Selfie Stick. Keep side extension within the handlebar width and follow local rules for rear projection. Summary The Insta360 Bike Tail Mount Kit creates a supported route to a wider cycling perspective. Its value comes from the complete two-point setup, correct seat-post fit and careful adjustment within the manufacturer’s road-use limits. Frequently Asked Questions Is A Selfie Stick Or Camera Included?ExpandCollapse No. The kit includes the mounting assemblies and hardware listed in Specs. A compatible camera and a supported Invisible Selfie Stick are sold separately. Can I Use Only The Tail Clamp For An Extended Camera?ExpandCollapse No. Insta360 requires the tail fixing to be used with the seat-rail support clamp for a selfie stick and camera. Do not use the tail mount alone for that setup. Which Selfie Sticks Are Supported?ExpandCollapse The official compatibility table supports the Action, 114 cm, 85 cm and 70 cm Invisible Selfie Sticks. The installation guide specifically recommends the Action, 114 cm or 85 cm models. Use the complete two-point support arrangement with the chosen stick. Will It Fit My Seat Post?ExpandCollapse The manufacturer lists a compatible seat-post clamping profile below 55 × 35 mm. The post shape and actual clamp fit must still be checked. Use the correct bracket arrangement and suitable protective cushioning without forcing the clamp. Can I Use It On Trails Or Bumpy Roads?ExpandCollapse No. The extended tail setup is intended for flat roads at no more than 60 km/h. Mountain, muddy and bumpy roads are not supported. Keep side extension within the bike’s handlebar width and comply with local rear-projection requirements. Read more