Insta360 X4 Air Standard Lens Guards

A Clearer Routine for Everyday Protection Keep a protective layer in front of X4 Air’s lenses when everyday filming brings the camera close to bags, clothing and the world around you. Insta360 X4 Air Standard Lens Guards use reinforced, multi-coated glass in a removable twist-on design. The camera recognises the fitted guards automatically, helping you move from preparation to recording with the right lens-guard mode in place. Highlights Reinforced glass for everyday bumps and scratches. Manufacturer-rated 7H glass, tested under laboratory conditions. Multi-coated optical surfaces for clear image capture. Automatic X4 Air lens-guard detection. Two removable guards and a lens cloth supplied. Key Features Add a Replaceable Protective Layer The reinforced glass provides an additional surface between the camera lenses and everyday contact. Insta360 rates the Standard glass at 7H under its laboratory test conditions. That figure helps describe the material; it does not make the camera or guards unbreakable, so keep the camera secure and avoid direct impacts. Keep Optical Surfaces in Good Condition Multiple coatings are designed to support light transmission and image quality. Cleanliness still matters: marks, dirt and scratches on a guard can affect the recorded image. Inspect both sides before fitting, use a soft lens cloth and replace a damaged guard instead of continuing to film through a scratched surface. Let the Camera Recognise the Guards After the screen-side guard is correctly installed, X4 Air displays the corresponding lens-guard indicator. Confirm the on-screen prompt before recording. The camera’s detection and stitching workflow accounts for the attached guards, while careful framing and clean glass help achieve the intended result. Twist into Position Align the guard with the lower-right lens slot and rotate it clockwise until its notch aligns with the microphone position. Check that both guards are firmly fitted without applying excessive force. Hold the guard base and turn it anticlockwise for removal, taking care not to touch or scratch the camera lens. Match Protection to the Conditions These guards are for supported dry-use filming. Their structure is not sealed, so avoid rain, surfing and other water-related use where moisture can enter and fog the glass. Remove the guards before using the appropriate X4 Air Invisible Dive Case, and keep the camera and guard surfaces dry before reassembly. Summary Insta360 X4 Air Standard Lens Guards offer reinforced-glass protection with a straightforward twist fit and automatic camera detection. Keep the surfaces clean, confirm the guard mode and choose dry filming conditions. The removable pair makes everyday lens care easier to build into your recording routine. Frequently Asked Questions Are These Made Specifically for X4 Air?ExpandCollapse Yes. This pair is designed for Insta360 X4 Air. X4, X5 and other camera generations use their own specified lens guards; a similar appearance does not establish compatibility. What Is the Difference from Premium Lens Guards?ExpandCollapse The Standard version uses reinforced glass rated at 7H in the manufacturer’s laboratory tests. The separate Premium version uses tempered glass rated at 10H. Both versions have multi-coated surfaces, twist fitting and automatic X4 Air detection. Do I Need to Switch Lens-Guard Mode Manually?ExpandCollapse X4 Air automatically detects the correctly installed guards. After fitting the screen-side guard, check the indicator and confirm the on-screen prompt before recording. Can I Use Them in Rain or Underwater?ExpandCollapse No. The guards are not sealed and are not intended for wet filming. Moisture can cause fogging. Remove them before installing the appropriate X4 Air Invisible Dive Case. What Does the Package Include?ExpandCollapse Two X4 Air Standard Lens Guards and one lens cloth. The camera, Lens Cap and dive case are separate. Inspect and clean the guard surfaces before every recording. 阅读更多