Insta360 Luna Ultra Sliding Protective Case

Ready for the Moment, Protected Between Shots Keep the Luna Ultra ready for a quick change of scene without leaving its gimbal exposed between recordings. This fitted Sliding Protective Case moves between a shooting position and a raised storage position. Slide it down to wake the camera, then switch the camera off before raising the case for protection. A compact installation tool helps seat the case correctly. The camera is shown for fit and is supplied separately. Highlights Purpose-made for Insta360 Luna Ultra, rather than Luna Pro. Downward sliding action wakes the camera for shooting. Raised position protects the gimbal during storage after power-off. Lightweight fitted design with an included installation tool. Choose the available colour to match your camera setup. Key Features Change from Carrying to Capturing The case remains fitted as you move between its two positions. Slide it down to wake the Luna Ultra when you are ready to frame the next scene. This reduces the separate handling of a loose cover when moving between short recordings, while keeping the camera controls available in the shooting position. Cover the Gimbal Before Storing Finish the recording and power the camera off before sliding the case upwards. The raised position surrounds the gimbal for storage. Follow the illustrated camera orientation and slide position rather than forcing the mechanism. The case is a fitted protective accessory, not a waterproof housing or a substitute for careful handling. Use the Installation Tool for an Even Fit Remove the Wind Guard as instructed and place the powered-off camera into the supplied installation tool in the specified orientation. Press the front and rear edges of the case into place. Check that the bottom edges on both sides sit flush with the tool before taking the assembled camera out. Keep the Setup Compact The case weighs approximately 20.5 g and combines plastic, metal, silicone and magnets. Its shaped construction is specific to Luna Ultra. To remove it, power the camera off, move the case to the illustrated release position and follow the side-release procedure; refit the Wind Guard when returning to that camera configuration. Summary Insta360 Luna Ultra Sliding Protective Case pairs quick camera access with a fitted storage cover for the gimbal. Correct installation keeps the sliding action straightforward. Choose the right colour, use the supplied tool and follow the power-off sequence before returning the camera to its protected storage position. Frequently Asked Questions Will This Fit Luna Pro?ExpandCollapse No. This Sliding Protective Case is the Luna Ultra version. Luna Pro has a different model-specific case; do not substitute it based on appearance. Does Sliding It Down Start a Recording Automatically?ExpandCollapse The manufacturer describes the downward movement as waking or powering on the camera for shooting. Check the camera state and recording controls before assuming footage is being recorded. Should I Turn the Camera Off Before Raising the Case?ExpandCollapse Yes. Power the camera off first, then slide the case upward for storage as shown in the guide. Follow the illustrated position and avoid forcing the gimbal or case. What Is Included?ExpandCollapse One Sliding Protective Case in the selected colour and one installation tool are supplied. The Luna Ultra camera is separate. The camera’s Wind Guard is removed for the prescribed installation procedure. Is This a Waterproof Housing?ExpandCollapse It is a fitted sliding storage protector. No added waterproof rating is specified. Continue following the camera’s own environmental and handling limits. 続きを読む