Insta360 Bike Headset Cap Mount

Put The Camera At The Centre Of The Ride The Insta360 Bike Headset Cap Mount creates a camera position above a compatible headset, keeping the setup close to the bike’s centreline. Fit a supported wide-angle camera for a first-person view or pair a 360° camera with the separately sold Action Invisible Selfie Stick for a different perspective. Its adjustable universal joint lets you set the angle before riding. Highlights Replaces a compatible standard OD1 28.6 mm headset top cap Adjustable universal joint for setting the shooting angle Supports direct camera setups or the Action Invisible Selfie Stick Installation screws, hex keys and camera adapter included For smooth-road cycling at a maximum of 50 km/h Key Features A Defined Headset Fit This mount is for a standard OD1 headset or fork steerer with a 28.6 mm diameter. It is not a universal fit for every bike, non-standard assembly or non-circular head tube. Confirm the bike’s specification and the condition of its fixing system before installation. First-Person Or Third-Person Framing Use an appropriate camera connection to capture the road from the front of the bike. With a compatible 360° camera, the Action Invisible Selfie Stick provides another filming position. Other selfie sticks are not supported by this mount, and the Standard package does not include a stick. Set The Angle Before Moving The mechanical universal joint allows the camera position to be adjusted and tightened while stationary. It is a positioning joint, not an electronic stabiliser. Check that the camera and any supported stick clear the wheel and do not interfere with handling or visibility. Fitting Hardware Included The package supplies the cap base, universal joint, two headset screws, three hex-key sizes, camera adapter, thumb screw, dust caps and anti-slip parts. The bike’s headset preload and fork fixing must remain correctly set. If you are unsure about fitting the assembly, have a competent bicycle technician check it. Keep The Mount Ready For The Next Ride Insta360 specifies smooth roads at a maximum of 50 km/h and excludes off-road use. Extend the supported stick horizontally away from the wheel without passing the front wheel. Fit the dust cap over the headset screw, wipe the mount dry after use and remove it for extended outdoor storage. Summary The Insta360 Bike Headset Cap Mount creates an adjustable camera point for a correctly specified bike. Its useful perspectives depend on the right headset fit, a secure installation and careful clearance around the front wheel. Frequently Asked Questions Will It Fit My Bike’s Headset?ExpandCollapse It is designed for standard OD1 headset or fork-steerer assemblies with a 28.6 mm diameter. It is not suitable for non-standard bikes or non-circular head tubes. Confirm the specification and fixing arrangement before purchasing or installing it. Which Selfie Stick Can I Use?ExpandCollapse Only the Insta360 Action Invisible Selfie Stick is supported. It is sold separately from this Standard package. If extended, keep it horizontal and away from the wheel, without extending beyond the front wheel. Can I Ride Off-Road With This Mount?ExpandCollapse No. Insta360 specifies smooth-road cycling at a maximum of 50 km/h. Off-road use is not supported. Set and secure the camera angle while stationary and inspect the fastenings before every ride. What Is Included In The Standard Package?ExpandCollapse It includes the headset cap base, universal joint, two headset screws, three hex keys, thumb screw, 3-prong to 1/4-inch adapter, dust caps and anti-slip parts. The camera and Action Invisible Selfie Stick are sold separately. How Should I Look After The Mount?ExpandCollapse Cover the installed headset screw with the supplied dust cap and wipe the mount dry after each use to reduce exposure to water and sweat. Remove and store it properly if the bike will remain outdoors for an extended period. 続きを読む