Insta360 Bike Seat Rail Mount

Keep The Riders Behind You In The Story The Insta360 Bike Seat Rail Mount creates a compact camera position beneath a suitable saddle, opening up a rear view of group rides and the route behind you. Its aluminium-alloy body attaches to the seat rails, with a 3-prong connection and supplied 2-prong to 1/4-inch adapter for an appropriate camera setup. It gives the handlebars back to the rider while keeping the recording position close to the bike. Highlights Under-saddle position for rear-facing riding footage Compact aluminium-alloy mount weighing approximately 44.3 g 3-prong connection with included 2-prong to 1/4-inch adapter 350 g manufacturer maximum load Direct camera mounting only; not compatible with spring seats Key Features A Different View Of The Group Ride Place a compatible camera beneath the saddle to record the riders, road and scenery behind you. Set the framing while stationary and make sure that the camera remains clear of the rear tyre across its adjustment range before tightening the mount. Compact Hardware At The Seat Rails The clamp and bracket secure around suitable saddle rails using the supplied bolts. The mount body is small and light, but the rail shape, saddle construction and available clearance still need checking. Bicycles with spring seats are not supported. A Connection For The Right Camera Setup The 3-prong mounting point and supplied 2-prong to 1/4-inch adapter accommodate an appropriate camera connection. Use the camera-specific mounting parts where required. This is a direct camera mount; a selfie stick must not be attached to the standalone Seat Rail Mount. Keep An X-Series Camera Clear Of The Wheel Vibration can allow an X-series camera setup to tilt towards the tyre. Stop and correct any movement promptly. Insta360 recommends a suitable Utility Frame when using an X-series camera on bumpy roads, and its current installation guide advises against combining an X-series camera with a Vertical-Horizontal Mount here. Inspect Before Every Ride Use the anti-slip parts and tighten the mount as instructed, then check camera security and tyre clearance. The manufacturer recommends staying below 60 km/h on smooth roads and below 40 km/h on uneven roads. Recheck the setup if you notice movement or a change in framing. Summary The Insta360 Bike Seat Rail Mount is a compact route to a rear-facing cycling perspective. Use the correct rail fit and camera connection, keep the camera clear of the tyre and stay within the manufacturer’s riding guidance. Frequently Asked Questions Will It Fit A Bicycle With A Spring Saddle?ExpandCollapse No. Insta360 states that the Bike Seat Rail Mount is not compatible with bicycles that use spring seats. Check the saddle-rail shape and available camera clearance on other bikes before fitting it. Can I Attach A Selfie Stick To This Mount?ExpandCollapse No. The standalone Bike Seat Rail Mount is for direct camera mounting. The separate Bike Tail Mount Kit uses additional support for an approved selfie-stick setup; it is a different product arrangement. How Do I Keep The Camera Clear Of The Tyre?ExpandCollapse Before riding, check the camera’s full adjustment range and tighten the mount securely. If vibration makes the camera tilt down, stop and correct it. Insta360 recommends a Utility Frame for an X-series camera on bumpy roads and advises against using a Vertical-Horizontal Mount with that setup. What Speed Guidance Applies?ExpandCollapse The manufacturer recommends cycling below 60 km/h on smooth roads and below 40 km/h on uneven roads. Inspect the mounting screws and camera connection before use and stop if the setup moves or approaches the tyre. What Comes With The Mount?ExpandCollapse The box includes the clamp bracket, main clamp, two 16 mm M4 bolts, a 2-prong to 1/4-inch adapter, thumb screw, hex wrench and four anti-slip rings. The camera and camera-specific mounting accessories are sold separately. 더 보기