Antigravity A1 Propellers

Genuine Replacement Blades for A1 Keep your A1 flight kit prepared with propellers designed for its motors and flight system. Antigravity A1 Propellers use precision-balanced blades to support efficient thrust and controlled flight noise. Their model-specific fit makes them the appropriate replacement when the original blades are worn or damaged. A spare pack is a practical part of your flight equipment. It lets you replace the correct matched blades and screws after inspection, rather than attempting another flight with a damaged component. Highlights Genuine propellers designed for the Antigravity A1. Two propeller pairs with 12 replacement screws. Precision-balanced blade design. 152 × 74 mm diameter and pitch specification. Marked and unmarked blades for the corresponding A1 motors. Key Features Designed Around the Aircraft The blade profile, mounting points and balance are intended for the A1 flight system. Use the specified propellers rather than a similar-looking generic blade, and match the blade markings to the correct motor position. Replace the Matched Set The current A1 manual requires the old propeller set and its screws to be discarded when replacing the blades on a motor. Use matched blades from the same package and new screws, then follow the prescribed fitting and tightening procedure. Make Inspection Part of the Flight Check the blades for cracks, deformation and other damage before take-off and after flying. If a propeller is damaged, complete the replacement before the next flight. Carrying the proper spare pack supports that routine without treating a damaged blade as usable. Summary Antigravity A1 Propellers provide the correct replacement blades and screws for routine A1 maintenance. Check the affected motor positions and required quantities before ordering, and follow the current manufacturer instructions when fitting the new parts. Frequently Asked Questions Are These Made for the Antigravity A1?ExpandCollapse Yes. They are the genuine A1 replacement propellers. Match marked blades to marked motors and unmarked blades to unmarked motors, following the current manual. Do not substitute them for a different drone model. What Is Included in One Pack?ExpandCollapse The manufacturer lists two propeller pairs and 12 screws. Each propeller pair has two blades, so the pack supplies four blades. The A1 aircraft and a screwdriver are not included in this standalone pack. When Should I Replace the Propellers?ExpandCollapse Inspect them before take-off and after each flight. Replace blades with cracks, deformation or other damage before flying again. Do not use a general flight-hour estimate as a reason to keep a visibly damaged blade. Can I Reuse the Old Screws or Mix Blades?ExpandCollapse The A1 manual says to discard the old propeller set and its screws from the corresponding motor. Use matched replacement blades from the same package and new screws. Follow the current installation procedure and specified tightening torque. Does One Pack Replace Every Rotor on the Drone?ExpandCollapse It contains two propeller pairs, rather than a complete four-motor set. Check which motor positions require replacement and the corresponding blade markings before ordering. Baca selengkapnya