Antigravity A1 Propeller Guards

A More Considered Approach to Close-Range Flight A narrow doorway or a close pass beside furniture leaves less room for error. Antigravity A1 Propeller Guards add a physical barrier around the propellers, helping protect against minor contact from the sides and below. Their purpose-built shape fits the A1 without relying on a generic attachment. Highlights Protection Where Space Is Limited The original A1 guard design is intended for indoor and obstacle-heavy environments where additional separation around the propellers is useful. It supports careful flight planning and controlled manoeuvres. A Fit Designed Around A1 Matched front, rear, left and right components connect using their alignment markings. Locking latches secure the assembled guards to the drone for a consistent installation. A Complete Flight Setup The guards change the aircraft’s weight and flying characteristics. Fit them before configuring the flight and image-stitching settings, so your setup reflects the equipment actually installed. Key Features Original A1 Guard Construction This is the original open-frame A1 Propeller Guards set. It adds protection around the propeller areas while retaining the manufacturer’s dedicated attachment arrangement. Secure Marked Assembly Match the front and rear components by their numbers and position markings, connect the guard sections, then close every latch as described in the A1 manual. Check that the assemblies are secure before take-off. Flight Characteristics to Plan Around With these guards installed, A1’s take-off weight exceeds 249 g and its maximum flight speed is limited to 12 m/s. Added equipment can also affect flight performance and battery endurance. Stitching Preparation for 360 Footage After installation, recalibrate the stitching settings in the Antigravity app and official editing software as directed by the manufacturer. Select the propeller-guard stitching setting when processing compatible footage. Summary Choose the original A1 Propeller Guards when your flight plan calls for an additional physical buffer around the propellers. Keep the route clear, allow adequate space and check the rules for the aircraft’s configured take-off weight. Guards reduce some contact risks; they do not make a flight collision-proof. Frequently Asked Questions Which drone do these propeller guards fit?ExpandCollapse They are designed for Antigravity A1. This listing is for the original open-frame guard set, rather than the newer Full-Coverage Propeller Guards supplied with the Follow Me Accessory Kit. Do the guards keep A1 below 249 g?ExpandCollapse No. Installing the guards takes A1’s take-off weight above 249 g. Check the requirements for your flight location and complete aircraft setup before flying. Does fitting the guards change speed or flight time?ExpandCollapse Yes. Maximum flight speed is limited to 12 m/s with these original guards installed. The additional weight also affects performance and battery endurance, so allow for the configured aircraft rather than an unguarded flight-time figure. Do I need to change the image-stitching settings?ExpandCollapse Yes. Follow the manufacturer’s recalibration procedure after fitting the guards. Antigravity Studio also provides a propeller-guard setting within its stitching controls. Can guards replace obstacle avoidance or careful piloting?ExpandCollapse No. They add a physical layer of protection against some minor contact, particularly from the sides and below. Keep people and obstacles clear and follow the A1 flight guidance. Magbasa pa